Open Access Open Access  Restricted Access Subscription Access

The RoboFriend Research Project

Sami Salama Hajjaj

Abstract


The RoboFriend project is a student-based research project created to utilize elements of Human-Robot Interaction (HRI) in tackling the problem of motion planning in dynamic environment for robots with higher DOFs. By developing a humanoid robotic arm (9 DOFs), to be controlled using visual and/or audio input signals from users, and use these queues to learn to avoid similar obstacles in the future. This project was divided into 4 major sub-projects; development of the gripper (wrist to fingers), development of manipulator (shoulder to wrist), development of the electronics and controls, and finally development of the HRI interface. Each sub-project was given to an engineering student, to be completed as his/her final year engineering project. Being a student-based project, this work had a secondary objective; to investigate the effectiveness of incorporating robotics research in undergraduate engineering education. Challenges included the design/development of the humanoid gripper, due to its conflicting design parameters of flexibility and structural stability. At the end, the humanoid arm was made to response to human voice. Data also showed that research enhanced students’ learning experience as students were able to demonstrate their recently acquired knowledge in contributing to this work. Therefore, it can be concluded that incorporating research in undergraduate engineering studies is effective.

Full Text:

PDF

References


Casper, J. Murphy, R. Human-robot interactions during the robot-assisted urban search and rescue response at the World Trade Center, IEEE Transactions on Systems, Man, and Cybernetics, vol 33 (3), pp 367–385, June 2003.

Druy. Jill, Hestand. Dan, et al. Design guidelines for improved human-robot interaction, Conference on Human Factors in Computing Systems archive. CHI '04 Vienna, Austria, pp 1540 – 1540, 2004, ISBN:1-58113-703-6

Kiesler. S, Hinds, P. Introduction to Human-Robot Interaction. Special Issue of Human-Computer Interaction, vol 19, no 1 & 2. 2004.

Adams, J. A. Human-Robot Interaction Design: Understanding User Needs and Requirements, Proceedings of the 2005 Human Factors and Ergonomics Society 49th Annual Meeting, September 2005.

A. Hofmann, B. Williams, Intent Recognition for Human-Robot Interaction, Proceedings of 2007 AAAI Spring Symposium - Interaction Challenges for Intelligent Assistants, pp. 60-62, Stanford University, USA, 2007

T. Asfour, P. Azad, N. Vahrenkamp, K. Regenstein, A. Bierbaum, K. Welke, J. Schröder, R. Dillmann, Toward humanoid manipulation in human-centered

environments, Robotics and Autonomous Systems, vol. 56, No. 1, pp. 54-65, 2008.

Scassellati, B. How robotics and developmental psychology complement each other. Proceedings of the NSF/DARPA Workshop on Development and Learning. Lansing, MI: Michigan State University. 2000

Maxwell, B. A. and Meeden, L. A, Integrating Robotics Research with Undergraduate Education, IEEE Intelligent Systems, November/December, 2000.

Mehrl, D. J, Parten E, and Vines. D. L, Robots Enhance Engineering Education, Proceedings of the Frontiers in Education Conference. 1997.

Rawat, K.S., and Massiha. H. H, A Hands-On Laboratory Based Approach to Undergraduate Robotics Education, Proceedings of the 2004 IEEE International Conference on Robotics and Automation, New Orleans, LA. April 2004.

Salisbury K., Mason M. T., Robot Hands and the Mechanics of Manipulation, M.I.T. Press. Cambridge, MA,1985.

Jacobsen. S. et al., Design of the Utah/M.I.T. Dexterous Hand, Proceedings of the IEEE International Conference on Robotics and Automation, San Francisco CA. 1520-1532. 1986.




DOI: http://dx.doi.org/10.21535%2FProICIUS.2010.v6.463

Refbacks

  • There are currently no refbacks.