Open Access Open Access  Restricted Access Subscription Access

Estimation of In-Flight Icing Characteristics of UAVs During Different Meteorological Conditions

Zsolt Bottyán

Abstract


The in-flight structural icing phenomenon is very important for the UAV's because it causes some serious problems such as reduced lift and increased drag forces, significantly decreased angle of attack, increased weight, sturctural imbalances and improper radio communications. In order to increase flight safety of UAV's we develop a meteorological support for the UAV pilots, mission controllers and decision makers, too. The mentioned support based on 3D observational data, statistical and numerical methods, as well. In our paper we show the in-flight structural icing estimation method as a part of this support system based on both a simple 2D ice accretion model and WRF numerical weather predictions. We point out the role of the air temperature, LWC and airfoil geometry in the icing process on the wings of UAVs. With the help of our system we made an estimation of geometry and amount of ice accretion on the wing of a shor-range and a HALE UAVs during a hypothetical flight under a typical icy weather situation with St clouds over the carpathian-basin (a case study). FInally we point out that our icing estimation system can easily be adapted for supporting the missions of other types of UAVs.

Full Text:

PDF

References


M.B. Bragg, A.P. Broeren, and L.A. Blumenthal, “Iced airfoil

aerodynamics”, Progress in Aerospace Sciences, vol. 41, pp. 323-362,

L. Makkonen, and J.R. Stallabrass, “Experiments on the cloud droplet

collision efficiency of cylinders” J. Clim. Appl. Meteorol. vol. 26, pp.

-1411, 1987.

B. Hansen, “A fuzzy-logic based analog forecasting system for ceiling

and visibility”, Weather and Forecasting, vol. 22, pp. 1319-1330, December 2007.

Skamarock, W.C., Klemp, J.B., Dudhia, J., Gill, D.O., Barker, D.M.,

Wang, W. and Powers, J.G., “A Description of the Advanced Research

WRF Version 2”. NCAR Technical. Note, Boulder, USA, pp. 1-88, 2005.

R.W. Gent, N.P. Dart, and J.T. Cansdale, “Aircraft icing”, Phil. Trans.

R. Soc. Lond. A., vol. 358, pp. 2873-2911, 2000.

F.H. Ludlam, ”The heat economy of a rimed cylinder” Quarterly Journal

of Royal Meteorological Society, vol. 77, pp. 663-666, 1951.

E.P. Lozowski, J.R. Stallabrass, and P.F. Hearty, “The icing of an

unheated, non-rotating cylinder. Part I: A simulation model”, Journal of

Climate and Applied Meteorology, vol. 22, pp. 2053-2062, 1983.

K. Szilder, and S. McIlwain, “In-flight icing of UAVs – The influence of

Reynolds number of the ice accretion process”, SAE Technical Paper,

-01-2572, 2011, doi:10.4271/2011-01-2572.

Z. Bottyán, “Estimation of structural icing intensity and geometry of

aircrafts during different conditions – a fixed-wing approach”, Idjárás,

vol. 115, pp. 275-288, 2011.

E.P. Lozowski, J.R. Stallabrass, and P.F. Hearty, “The icing of an

unheated, non-rotating cylinder. Part II: Icing wind tunnel experiments”,

Journal of Climate and Applied Meteorology, vol. 22, pp. 2063-2074,

J-C. Tsao, and D.N. Anderson, “Additional study of water droplet

median volume diameter (MVD) effects on ice shape” NASA/CR-2005-

report, pp. 1-11, 2005.

Geresdi, I. Rasmussen, R.M., Thompson, G., Manning, K., and Karplus, E., “Freezing drizzle formation in stably stratified layer clouds: The role of radiative cooling of cloud droplets, cloud condensation nuclei, and ice initiation” Journal of Atmospheric. Sciences, vol. 59, pp. 837-860,




DOI: http://dx.doi.org/10.21535%2FProICIUS.2012.v8.772

Refbacks

  • There are currently no refbacks.